For all machine versions

Check that the chinstrap works properly.

As a reminder, chinstrap height adjustment is done with the chin NOT in place.

Version with blue crossed rails

• Check the position of the camera block. It must be centered on its mounting block.
  
  
• If the block is well centered, check that the BLUE clamping screw is correctly tightened
  
  

• If the block is not centered,

• Slightly loosen the BLUE locking screw and move the block to re-center it.

• Retighten the BLUE locking screw.

• Check the position of the Left/Right rail by positioning the L/R carriage on 8 and checking that the carriage is aligned with the left side of the rotation block.
  
  

If the rail is aligned,

• Check that the clamping screw is correctly tightened

                    Set  on 8                                                                 Good alignment from 0 to 5 mm                                            If good, check tightening of BLUE screw

If the rail is not correctly aligned,

• Slightly loosen the locking screw and move therail so that the left side of the carriage coincideswith the left side of the rotation block.
  
  
• Retighten the locking screw

                     Set on 8                                                                SHIFT Right or left to                                     ALIGN between 0 and 5 mm and tighten the blue screw

• Check that the racks are free of dust or solid particles
  c
• Clean the 2 rails with a clean cloth
  
  

Screws may not be handled unless expressly requested by an IRIS Galerie head office manager.